How iTe works

The following L^ATEX2_e code is a minimal working example.

   \documentclass{article}
   \usepackage{ite}
   \begin{document}

   \begin{iteblock}(5cm,5cm)
   \ite Hello
   \ite World
   \end{iteblock}

   \end{document}

It defines two active iTe objects (`Hello' and `World'). Upon starting iTe, active objects can be manipulated interactively. The possible operations are translation, rotation and scaling. The origin for these operations is the lower left corner of the box defined by the iteblock environment. For an active object, iTe establishes a one-to-one relationship between its L^ATEX source code and the corresponding PostScript code fragment. All operations are then simultaniously recorded in both the L^ATEX source and in the GhostScript window. For example, if the `Hello' is translated, rotated by 90 degrees and scaled by a factor of 2, then the corresponding L^ATEX source will look like this:

   \ITE(50 70 90 2) Hello

Sometimes, you might be pressed to define iTe objects inside macros or saved boxes. If this is the case, many PostScript code fragments may correspond to one L^ATEX source object. Here you have to use passive objects. The use of active objects inside macros and saved boxes is not checked and will utterly confuse iTe. Passive objecst behave like active objects, but cannot be manipulated interactively. See the definition of the itebind latex environment on how to generate passive objects.

These binaries (installable software) and packages are in development.
They may not be fully stable and should be used with caution. We make no claims about them.